51308307-175 Honeywell Power module Brand new

Refer to the following instructions for making power connections to the FOE module on DIN rail

from TDI power supply option.

1. Mate the power connector of the 51202948-100/51202948-200 to the free output port on top

of the TDI power supply as displayed in the figure.

2. Connect the power cable 51202948-100/51202948-100 to the terminal block on DIN rail.

Perform the following to do so:

Open the fuse holder using the lever provided.

Insert the ferrule of one of the two red cables into the fuse terminal marked '+'.

Fasten the corresponding screw inside the terminal block, below the fuse holder.

1. Connect one of the two black cables to the 'V-' terminal of the power connector on the FOE

module.

2. Connect one of the free ends of the 5-inch red cable into the '-' fuse terminal of the terminal

block on DIN rail and the other end to the 'V+' terminal of the power connector on the FOE

module.

3. Repeat steps 2 through 4 to make power connections to the other FOE module.

- 526 -

Chapter 13 - Series C I/O Link Fiber Optic Extenders (FOE)

13.5.12 Replacing the FOE fuse on the terminal block when FOE is

mounted on DIN rail

To replace the FOE fuse on the terminal block when the FOE is mounted

on the DIN rail

1. Using the lever provided on the terminal block, open the fuse holder.

2. Remove the fuse from the fuse holder.

3. Replace the fuse by positioning it in the fuse holder, press and fit.

4. Close the fuse holder and press the lever to lock.

13.5.13 Removing the FOE module from the DIN rail

To remove the FOE module from the DIN rail

1. Power down the FOE module by opening the fuse holder of the terminal block using the lever

and removing the fuse

2. Remove all the cables before detaching the FOE modules. Perform the following steps to do so.

a. Unscrew and remove the cable (HPN 51202930-200) running from the feed through

terminal of the system cabinet to the '+' fuse terminal of the terminal block

(Meanwell/Phoenix Contact power supply only).

b. Remove the power connector of the cable (HPN 51202948-100/51202948-200) from the

power supply by releasing the lock in the side and pulling it out gently (TDI power supply

only).

c. Unfasten the screw of the '-' fuse terminal of the terminal block on DIN rail and remove

the cable.

d. Unfasten the screw of the 'V+' terminal of power connector on the FOE module and

remove the cable.

e. Unfasten the screw of the '-' terminal of the feed through terminal block and remove the

cable.

f. Unfasten the screw of the 'V-' terminal of power connector on the FOE module and

remove the cable.

g. Remove the fiber optic cables from the FOE module by pulling it out gently.

h. Unscrew and remove the I/O Link cable (HPN 51202789-910 / 51202789-911) from the

FOE module or remove the I/O Link connector by pulling it out.

3. Unfasten the screw in the center of the end bracket and remove it by slightly lifting and pulling

it out.

4. Push the FOE module slightly downwards and slide it out at the lower edge of DIN rail.