38500148-300 Honeywell Central control module Brand new

General regulatory compliance

Regulatory and agency approvals, for the product described in this document, are only applicable

to the product as delivered by Honeywell. Any deviation to the product and or installation

- 281 -

instructions, as provided by Honeywell, must be evaluated with regard to all local regulatory

requirements. It is the responsibility local Authority Having Jurisdiction (AHJ) to ensure the

suitability of the installation of this product and to assess the impact to the installed base

certification with regard to all regulatory requirements.

The product described in this document must be installed within an enclosure providing adequate

protection for the intended environment and meeting all local regulatory requirements. Refer to all

installation instructions provided with the product. It is the responsibility of the local Authority

Having Jurisdiction (AHJ) to ensure the suitability of the enclosure and final installation with

regard to all regulatory requirements.

The electromagnetic compatibility (EMC) of the product described in this document has been

verified, for the intended environment, when installed in an enclosure.

The product described in this document must be installed according to Honeywell Process

Solution system configuration rules and installation instructions and within an enclosure

providing adequate electromagnetic interference (EMI) protection, for the intended environment.

The enclosure should be made of electrically conductive material (metallic) and be enclosed on all

sides, with minimal openings. The enclosure chassis must be electrically bonded to protective

earth (PE) according to the installation instructions and local electrical code. Openings in the

enclosure should not have a dimension larger than 5mm (maximum hole diameter or slot length).

Openings in the enclosure with a dimension larger than 5mm, such as vent holes or fan grills,

should be covered with wire mesh (metallic) screen and the wire mesh electrically bonded to the

enclosure chassis in multiple locations around the perimeter of the opening. The wire mesh

should not have openings with dimensions larger than 5mm. Refer to all installation instructions

provide with the product. It is the responsibility of the system owner and the local Authority Having

Jurisdiction (AHJ) to ensure the suitability of the enclosure and the EMI protection provided by the

enclosure